Pro 7 5v2: Flexisign

Also – anyone else remember having to manually adjust the COM port settings for hours just to get a plotter to talk? Title: PSA: FlexiSIGN Pro 7.5v2 cracks are dangerous – avoid them

That said, if you are looking for a (e.g., for a forum, Facebook group, or tech support board), here are a few options depending on your goal: Option 1: Help / Troubleshooting Post Title: Need help with FlexiSIGN Pro 7.5v2 – Dongle/Driver issues on Windows 10 flexisign pro 7 5v2

Does anyone still run this version successfully on modern hardware? Alternatively, has anyone migrated their cutter/plotter settings to a newer version of Flexi (like Flexi 12 or 19) without re-creating every profile? Any advice is appreciated. Also – anyone else remember having to manually

Cleaning out the shop today and found an old PC running FlexiSIGN Pro 7.5v2 with the parallel port dongle still attached. Fired it up – and it still works! Any advice is appreciated

However, I need to provide an important heads-up: . It was designed for Windows XP/Vista/7 (32-bit) and uses a hardware parallel port or USB dongle (HASP key) for activation. It is no longer supported by SAi, and modern operating systems (Windows 10/11 64-bit) will likely have compatibility and driver issues.

Hey everyone – I’m running an older setup with Flexi 7.5v2 and a LPT1 parallel port dongle. I recently tried moving my production computer to Windows 10, but the HASP driver won’t install properly. I’ve tried compatibility mode (XP SP3) and disabling driver signature enforcement, but no luck.