✅ Fits in tight spaces on a tractor valve bank or in a hydraulic block. The zinc-plated or nitrided steel body resists corrosion from field chemicals.
❌ Standard NBR seals harden and leak after prolonged operation above 80°C (176°F). Upgrade to FKM if your tractor runs hot (e.g., continuous PTO work in summer). fendt 1d.2.1a
✅ External hex screw with locknut. Turn clockwise to increase outlet pressure. Many users appreciate that it doesn’t drift with vibration. ✅ Fits in tight spaces on a tractor
✅ Still supported by AGCO/Fendt aftermarket and generic hydraulic suppliers (e.g., Bosch Rexroth, HANSA-FLEX often have cross-references). Cons – Known Weaknesses ❌ Not Suitable for High Flow Above 40–45 L/min, pressure drop increases sharply and regulation becomes unstable. Use a larger NG10 valve for higher flows. Upgrade to FKM if your tractor runs hot (e
❌ Some users report inability to go below ~10–12 bar even when fully backed off. Check your specific “A” variant – some are pre-set with a minimum spring.
❌ Reverse flow from outlet to inlet is not possible. If your circuit needs load-holding, add an external pilot-to-open check valve.
✅ More tolerant of moderate contamination than some precision electronic valves. The direct-acting design responds quickly without complex internal pilot lines.